GM 25767914
Cooling Fan, Passenger Side

Start the replacement process of the Radiator fan and motor by taking away the air deflector and disconnecting the electrical connector of the Radiator fan. The auxiliary transmission cooler lines require disconnecting with the j 44827 (Transmission Cooler Quick Disconnect) because this special tool protects the Radiator and transmission and cooler from damage. Start your procedure by moving auxiliary cooler lines to safety before removing the two bolts that hold the Radiator fan assembly and proceeding to unscrew the lower bolt and the fan assembly bolt and the upper bolt before removing the assembly from the vehicle. Position the Radiator fan assembly inside the vehicle before bolting lower components (1, 2) while tightening them to 6.5 nm (58 inch lbs.). Setup the direct fan assembly bolt by securing it at 6.5 nm torque level, then add all remaining Radiator fan bolts with 6.5 nm torque completion. Press the auxiliary transaxle oil cooler line into the cooler until it locks in position and confirm the secure connection by applying gentle tension on the line. Connect the Radiator fan electrical wires while installing the air deflector and check the transmission fluid amount.

The replacement process starts with air deflector removal along with disconnecting the auxiliary Radiator fan electrical connector. The transmission cooler quick disconnect tool (J 44827) should be used to separate auxiliary transmission lines without harming either Radiator or transmission or Transmission Oil Cooler. Start by placing auxiliary cooler lines aside and the auxiliary Radiator fan assembly bolts (1, 2) out of the way before removing the lower left auxiliary Radiator fan bolt, the auxiliary Radiator fan assembly bolt and the upper left auxiliary Radiator fan bolt to remove the assembly from the vehicle. You should reinstall the auxiliary fan assembly into the vehicle followed by tightening the lower bolts (1, 2) to 6.5 nm (58 inch lbs.). Attend to the installation of the fan assembly bolt at the specified torque level. After that apply 6.5 nm (58 inch lbs.) to the other auxiliary Radiator fan bolts. Insert the auxiliary transaxle oil cooler line into its place until it secures properly then test its stability by a gentle pull on the line. Install the auxiliary Radiator fan electrical connector before placing back the air deflector. Check the transmission fluid level as the last step of the inspection.

Push the auxiliary transaxle oil cooler line into the cooler until it engages, gently tugging on the transmission oil cooler line to verify proper engagement.