GM 19179679
Tail Lamp Assembly, Passenger Side

You should start by opening the endgate or liftgate to replace tail lamp assemblies and back up lamps and sidemarker lights as well as stop and turn signal bulbs. Start by removing tail lamp assembly screws before turning bulb sockets 1/4 turn counterclockwise to release them from the assembly. Remove the bulbs from their sockets and insert new bulbs into their places. Turn the bulb sockets 1/4 turn clockwise after you connect them with the tail lamp assembly before you return the tail lamp assembly to the vehicle. Screw the tail lamp assembly into place using 1.9 n.m (17 lb in) torque and finish by closing the endgate or liftgate.

Start by opening the endgate or liftgate before you try to replace the tail lamp assembly or back up, sidemarker, stop, and turn signal bulbs. Take out the screws that connect the tail lamp assembly to the vehicle, then turn each bulb socket 1/4 turn counterclockwise to take them off the assembly. Turn the bulbs around so you can take them out of the sockets. To put the bulbs in, insert them into their sockets and then twist the sockets clockwise 1/4 turn onto the tail lamp assembly. Put the tail lamp assembly back on and attach it with the screws, making sure they are tightened to 1.9 n.m (17 lb in). When you have finished, close the endgate or liftgate.

First, open the endgate or liftgate to replace the tail lamps. The screws holding the tail lamp assembly to the car will then need to be removed followed by rotating the bulb sockets quarter turn counter clockwise to free them from the tail lamp assembly, then removing the bulbs from the sockets. For the installation, place the bulbs into the sockets and connect the bulb sockets to the tail lamp assembly by turning them 1/4 turn clockwise. Following that, replace the tail lamp assembly to the vehicle and fix it with screws that should be tightened up to 1.9 n.m (17 lb in).

In order to service the tail lamp, you will have to disconnect the battery negative cable first. Drill out the screws (of the outer tail lamp assembly), which fix the tail lamp unit to the vehicle and replace the screws if previously removed (warm up the outer tail lamp assembly), then press in to insert in the key holes from inside if they cannot be pushed through from the outside, remove from the outside holding the bottom edge and from the inside, then json nto the fiber rein according to the button, remove body liftgate limiter. Make a 1/4 turn in the counter-clockwise direction to disconnect the bulb sockets from the tail lamp assembly, with the bulbs removed from the sockets. For installation, replace the bulbs in the sockets and tighten the sockets to the tail lamp assembly by turning a 1/4 turn clockwise. Reconnect the tail lamp assembly to the vehicle and hearten the screws to secure by tightening to 1.9 n.m (17 lb in). Finally connect the battery negative cable.

Remove the screws that secure the tail lamp assembly to the vehicle.