Q: How to replace the Back Up Light and Tail Light in a European car on Chevrolet Corvette?
A: Start by removing screws that lock the tail/back up lamp assembly to the rear fascia surface before you remove the lamp to expose the tail and back up lamp sockets. Initiate socket detachment from the lamp assembly through counterclockwise rotation to release the locking tabs and extract the bulbs (when needed) from the sockets. Begin by inserting new bulbs into the lamp sockets and return the sockets to the lamp assembly through a clockwise rotation until the locking mechanism engages. Place the tail/back up lamp assembly onto the rear fascia before installing the screws while tightening retaining screws to 2 n.m (18 lb in).
Q: How to change the Back Up Light in the rear compartment on Chevrolet Impala?
A: To install or replace the back up lamp use these steps. Start with opening the rear compartment then take out the wing nuts from specific studs on the back up lamp holder. Turn the back up lamp sockets counterclockwise on the rear compartment lid applique to remove them before taking out the lamp bulbs from their sockets. Insert back up lamp bulbs into their sockets and install sockets onto the back up lamp by rotating them in a clockwise direction. Fasten the rear compartment lid applique to its position on the container lid and bolt it to the studs using hand-tightener settings. Finally, close the rear compartment.
Q: How to service and repair the Back Up Light on Chevrolet Malibu?
A: To access the back up lamp start by taking out the cargo net retainers and cargo net from the rear compartment. Lift the rear compartment trim to see the tail lamp nuts before taking them off. Remove the circuit board from the tail lamp after disconnecting its electric connector and releasing all maintenance tabs. Then take the bulbs from their sockets. Insert bulb fixtures into their sockets until they lock in place. After that, snap the circuit board onto the tail lamp retainers with proper tab seating. Attach the tail lamp electrical connection then put the lamp onto the quarter panel and put in nuts but keep them loose to install. Refold rear compartment trim to its normal position while tightening rear cargo net retainers after adding the cover back to them.