GM 15070500
Accessory Bezel Insert

Users should first remove the center seat before replacing the front seat cup holder while protecting their eyes from injuries caused by rivet drilling. You must first unscrew the rivets situated at the bottom of the center seat before the cup holder can be extracted. The installation process requires fitting the new cup holder properly into position followed by securing it with rivets that need to be attached at the bottom of the center seat. Reinstallation of the center seat completes the process.

The first step to replace the front seat cup holder requires removal of the center seat with eye protection to protect from potential drilling-related injuries when securing the cup holder to the bottom of the center seat. The cup holder becomes accessible after eliminating all the rivets. Insert the new cup holder by placing it into position and fastening the rivets at the center seat bottom before reattaching the center seat.

Begin by lowering the Cup Holder after which a flat bladed tool can separate the Cup Holder from the console by inserting it between the Cup Holder hinge and end panel. To install the Cup Holder begin by placing one hinge into the panel opening then swing the assembly until the second hinge fits into the opposing opening before conducting a correct operation check.

The first step to swap the front floor console Cup Holder (Luxury) is to extract the upper trim bezel that covers the Center Console. Secondly remove the remote cd player only if your vehicle is equipped with this feature. The flat-bladed tool should be used to slide between the console and Cup Holder assembly before gently prying the assembly to free the two clips. Unplug the wire connector for the Cup Holder before taking off the Cup Holder from its console position. To install the Cup Holder assembly place it over the console before establishing its wire connector. Apply firm pressure to the corners of the Cup Holder assembly until you feel that its two retaining clips are properly seated. Reinstall the remote cd player after completing the installation with the upper trim bezel.

The replacement of the front floor console cup holder (Non-Luxury) requires you to grab the middle of the cup holder and pull outwards to remove clips then remove the cup holder from the console. For installation, push the cup holder inwards while the clips click into position, ensuring the corners of the cup holder are seated right.

The first step to replace the front seat cup holder requires removal of the center seat with eye protection to protect from potential drilling-related injuries when securing the cup holder to the bottom of the center seat. The cup holder becomes accessible after eliminating all the rivets. Insert the new cup holder by placing it into position and fastening the rivets at the center seat bottom before reattaching the center seat.

Inserting a flat bladed tool between the Cup Holder hinge and end panel will enable you to pry the Cup Holder off from the console after lowering the Cup Holder. You should start by inserting the first hinge through one of the panel openings then swing the Cup Holder assembly to fit the second hinge in the opposite side of the opening while verifying correct functioning of the assembly.

The first step to replace front seat cup holders requires removal of the central seat with protective eye equipment to avoid injuries from rivet drilling. First remove the rivets which secure the cup holder from the bottom of the center seat before removing the cup holder itself. Set the new cup holder in its designated position before security it via the rivets on the center seat bottom and return the center seat.

Use a flat bladed tool to pry between the console and the cupholder assembly, releasing the clips to remove the cupholder assembly.

Take out the rivets that secure the cupholder from the bottom of the center seat and then remove the cupholder itself.

Between the cupholder hinge and the end panel.