Make sure this part fits

GM 9386599
Control Module

2000-2005 GM

Customer Questions & Expert Answers (10)
GM 9386599 Control Module
  • Part Description
    Module, Electronic Suspension Control; Suspension Control Module
  • Manufacturer
    General Motors
  • Manufacturer's Notes
    This part is discontinued.
Make sure this part fits
  • Vehicle Fitment

    Year Make Model Trim Engine
    2000-2005 Cadillac DeVilleBase, DHS, DTS, Protection Series8 Cyl 4.6 L GAS
    2000-2002 Cadillac SevilleSLS, STS8 Cyl 4.6 L GAS
    Warning: California's Proposition 65
  • Customer Questions & Expert Answers

    Q:
    Hey, is 9386599 a good match for my vehicle? Posted by ChevyPartsGiant Specialist
    A:
    Please Select Your Vehicle model to see if part number 9386599 is suitable before ordering.
    Posted by ChevyPartsGiant Specialist
    Q:
    How to replace the Electronic Suspension Control Module (F55) on Cadillac Seville? Posted by Customer
    A:
    You should start the Electronic Suspension Control Module (F55) replacement by disconnecting the rear storage compartment trim and the two bay board fasteners. Set the bay board at a distance from the body surface and position it with the module side facing up in the rear compartment. You should depress the locking tab to remove the ESC module from the bay board. Then disconnect the harness connectors from the ESC module. The installation requires plugging harness connectors into the ESC module then placing the ESC module into bay board tabs followed by locking tab installation until bay board placement at the vehicle body where Fastener Notice must be noted in Service Precautions. The bay board installation requires you to fasten the retaining nuts before tightening them to 9 Nm (80 inch lbs.). Afterward, install the rear storage compartment trim. Complete the procedure by programming the ESC module followed by scanning a tool to execute the Bump Stop Trim Set process.
    Posted by ChevyPartsGiant Specialist
    Q:
    How to replace the Electronic Suspension Control Module (ESC module) on Cadillac DeVille? Posted by Customer
    A:
    The first step in replacing an electronic Suspension Control Module (ESC module) is to take out the rear seat back and shift the rear seat back insulator. The esc module removal starts with disconnecting electrical connectors while pressing the locking tabs inward so you can slide the module towards the vehicle center to remove it from its bracket. Location the esc module onto the bracket then push it from the vehicle center while it engages fully before establishing the esc module electrical connection. Reinstall the rear seat back while placing its insulator in position. The person installing the new ecm should calibrate the control module to remove dtc c0563 while making sure the scan tool operates with the most current chassis application program. Follow the scan tool readout instructions to install the connector on the dlc data link while turning on the ignition with engine off.
    Posted by ChevyPartsGiant Specialist
    Q:
    What is the first step to replace the Electronic Suspension Control Module for the 2000 Cadillac DeVille? Posted by Customer
    A:
    Begin by removing the rear seat back and moving the rear seat back insulator aside.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Suspension Control Module
    Q:
    What should you do after depressing the tabs on the CVRSS module for the 2001 Cadillac DeVille? Posted by Customer
    A:
    Slide the CVRSS module towards the center of the vehicle and remove it from the bracket.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Suspension Control Module
    Q:
    What should be ensured regarding the scan tool before starting the calibration for the 2002 Cadillac DeVille? Posted by Customer
    A:
    The scan tool must have the latest version chassis application program.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Suspension Control Module
    Q:
    How do you install the new CVRSS module for the 2003 Cadillac DeVille? Posted by Customer
    A:
    Position the CVRSS module onto the bracket and slide it away from the center of the vehicle until fully engaged.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Suspension Control Module
    Q:
    What should be done after reinstalling the CVRSS module for the 2000 Cadillac Seville? Posted by Customer
    A:
    Close the rear electronics compartment and reinstall the rear compartment trim panel.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Suspension Control Module
    Q:
    What should be done after installing the ESC module for the 2002 Cadillac Seville? Posted by Customer
    A:
    After closing the rear electronics compartment, reinstall the rear compartment trim panel and perform the ESC module Calibration.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Suspension Control Module
    Q:
    What is the first step to replace the Electronic Suspension Control Module for the 2001 Cadillac Seville? Posted by Customer
    A:
    First, remove the rear compartment trim panel and access the rear electronics compartment.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Suspension Control Module
    If you have any questions about this product, please don't hesitate to ask us. We will be happy to help you!

OEM GM Control Module 9386599 Designed for Proper Fit and Performance

Original OEM GM parts deliver superior quality and meet all performance standards needed for optimal automotive operation. The authentic part identified by 9386599 Control Module is available in the market under the name GM Suspension Control Module. This genuine product has a full warranty coverage from the manufacturer available at all authorized GM dealers throughout the United States. This part 9386599 Control Module fits certain Cadillac DeVille, Seville models.
The original GM component designated by manufacturer part number 9386599 maintains top performance when functioning as the Module, Electronic Suspension Control; Suspension Control Module unit. The component 9386599 is constructed from durable material and its dimensions span 10.0 x 6.8 x 3.6 inches while weighing 1.60 Pounds. The Direct Replacement component is ready in New condition to ensure full compatibility with your vehicle system. This component receives the designation of Module; Module, Electronic Control Suspension. The part 9386599 has available replacement options. GM manufacturer provides a warranty that ensures reliable operation of this product. The Shipping Policy and Return Policy pages outline complete details regarding shipping procedures and return processes.
If you want to save money in the long run on maintenance and repairs, you should choose OEM products because they're of the top level of durability. Are you on the quest of finding GM parts, our site is worth a visit. We stock an endless selection of high-quality GM components including things like ignition coils all the way through to fan shrouds and all at prices that can not be matched. You have nothing to worry about because all our OEM parts are covered with a manufacturer warranty, which guarantees superior quality and value.