Original OEM GM parts deliver superior quality and meet all performance standards needed for optimal automotive operation. The authentic part identified by 24226707 Extension Housing Seal, Front is available in the market under the name GM Transfer Case Seal, Transmission Gasket, Automatic Transmission Seal. This genuine product has a full warranty coverage from the manufacturer available at all authorized GM dealers throughout the United States. This part 24226707 Extension Housing Seal, Front fits certain Chevrolet Express 2500, Express 3500 models, as well as GMC Savana 2500, Savana 3500 models.
The original GM component designated by manufacturer part number 24226707 maintains top performance when functioning as the Seal Assembly-Propeller Shaft Front Slip Yoke Oil; Automatic Transmission Extension Housing Seal; Transmission Seal unit at its Front. The component 24226707 is constructed from durable material and its dimensions span 3.9 x 4.1 x 1.7 inches while weighing 0.50 Pounds. The Direct Replacement component is ready in New condition to ensure full compatibility with your vehicle system. This component receives the designation of Seal, Rear Bearing Retaining; Seal, Transmission Extension; Seal, Transfer Case. The part 24226707 has available replacement options 19133151. GM manufacturer provides a warranty that ensures reliable operation of this product. The Shipping Policy and Return Policy pages outline complete details regarding shipping procedures and return processes.
The GM part 24226707 Extension Housing Seal, Front is an important detail that is meant to avoid oil spillages in the transmission housing extension which may happen as a result of wear and tear over time. This oil seal is situated at the back of the transmission where the drive shaft is connected and it is very important in ensuring that the lubrication is adequate and to stop the accumulation of fluids that may cause other mechanical problems. Routine check and service of the GM part 24226707 should be done and leakage must be discovered after which a repair measure will be undertaken by safely lifting up the vehicle, removing the drive shaft and removing the old seal carefully without damaging the output shaft splines. Installation of the new oil seal has to be done with the help of a seal driver that will ensure that the new seal is properly seated and the splines have to be lubricated with a lightweight grease to make them move smoothly. To be at its optimally, using authentic parts will ensure that you remain on factory specification and our site sells a wide range of OEM GM parts, including the 24226707 Extension Housing Seal, Front, at fairly low prices and with a warranty on the manufacturer to assure you of quality and a warranty.