GM 10364167
Switch Assembly, Passenger Side

You start the side window switch and driver Door Lock replacement by pulling the switch panel front edge to remove the front retaining clip and afterward pull the rear edge to detach both rear retaining clips. The replacement process requires disconnecting electrical connectors from the driver door module when installed but excludes the module removal unless only performing a driver door module swap. First disconnect all remaining electrical connections from the switch panel before taking the switch panel assembly from the vehicle while keeping the driver door module set for transfer. First install the driver door module into the door trim panel while connecting its electrical connector to proceed with installation. When replacing the switch panel only it is essential to establish all other electrical connector connections. Follow the programming and personalization description and operation details in personalization by using the service programming system (SPS) with remote procedure, pass-thru procedure, off board remote procedure or off board pass-thru procedure to program the driver door module. Note that setup procedures have to be completed. To complete the installation of the switch panel you must place it inside the door trim panel where both retaining clips should be fully engaged.

The first step to replace the passenger door Power Window Switch requires the user to lift the switch panel front edge to free the front retaining clip followed by lifting the rear edge to release the two rear retaining clips. The electrical connectors must be detached from the passenger door module unless replacing this module only and then the module should be extracted from the door trim panel. The replacement process involves disconnecting all electrical connectors from the switch panel before retaining the passenger door module which will transfer if only the switch panel needs to be replaced. Remove the switch panel assembly that belongs to the vehicle. Install the passenger door module on the door trim panel followed by its electrical connector connection. The remaining electrical connectors should be connected when replacing the switch panel. The setup procedure needs to be completed during passenger door module replacement and follows programming instructions specified in dcm programming/rpo configuration. Mount the switch panel onto its position on the door trim panel while making sure the front and back retaining clips push all the way into place.

Reconnect the electrical connector to the switch and reinstall the rear quarter trim panel.

Place the switch back into the bezel, ensuring the retainers are fully seated, then connect the electrical connector to the window switch.