OEM 2000 Cadillac DeVille Brake Pad

2000 Cadillac DeVille Brake Pad Parts Questions & Experts Answers

• Q: How to replace the rear brake pads (J55) on 2000 Cadillac DeVille?

  A: To change the rear brake pads (J55), commence by draining off two-thirds of the brake fluid from the master cylinder, lifting and supporting the vehicle. Mark the relationship of the wheel to axle flange, and remove the wheel. Don't use the screwdriver or pry bar to squeeze the caliper piston, as this could destroy the piston boot and may result in corrosion. Instead, the use of a large c clamp to squeeze the caliper piston all the way to the caliper bore. Next, remove the lower caliper slide pins and pull off the caliper from the anchor and prop up as necessary. Remove the inboard and outboard pads from the anchor bracket and inspect the pad retainers. Inspect the check the caliper bolt suspension boots for cuts, tears, and wear, and replace them if necessary. Inspect the piston boot for damage, and replace it if necessary. Also review the caliper pin bolt for any damages or for corrosion to replace it if it is compromised. In terms of installation, install the Brake Pad retainers into the caliper anchor bracket, then the brake pads on each side. If new pads are used, then be sure that the caliper piston is perfectly bottomed out in the caliper bore using the large c clamp so that the piston boots lay flat with convolutions tucked. Use a small plastic or wood tool to lift up the inner lip of the boot next to the piston and squeeze out any air trapped. Mount the caliper to the Brake Pad onto the anchor bracket and then install the caliper slide pins which tighten it to 85 nm (63 ft. Lbs.). Install the tire and the wheel assembly back, lower the vehicle and start it. A force of about 778 nm (175 ft. Lbs.) is applied to the brake pedal three times to seat the Brake Caliper Piston and brake pads; afterwards, the burnish pads and rotors.