How to replace the blower motor resistor on 2000 Cadillac Seville?

To change blower motor resistor, one needs to unfasten the console trim plate, unplug the electrical connector, and also remove the rear fasteners then unscrew the resistor. Installation To install, pre-set the new resistor, screw it in with the rear studs, re-connect the electrical connector, and screw the console trim plate back in.

OEM 2000 Cadillac Seville Blower Motor Resistor

Heater Blower Motor Resistor

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 Blower Motor Resistor found

View related parts
2000 Cadillac Seville Control Module Part Number: 52480042
Product Specifications
- Other Name: Module, Blower Motor Control; Module; Module, A/C Electric Temperature And Motor Control
- Replaces: 52474881
- Item Weight: 0.90 Pounds
- Item Dimensions: 6.3 x 4.3 x 4.3 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 52480042
- Warranty: This genuine part is guaranteed by GM's factory warranty.
More Info
Fits the following 2000 Cadillac Seville Submodels:
- SLS, STS | 8 Cyl 4.6 L GAS

2000 Cadillac Seville Blower Motor Resistor

With a comprehensive array of OEM 2000 Cadillac Seville Blower Motor Resistor, from fuel pumps to door handles, our website is a one-stop-shop for your needs. All our genuine 2000 Cadillac Seville Blower Motor Resistor are backed by the manufacturer's warranty and are offered at competitive prices in the market. Rest assured, you can shop with complete confidence.

2000 Cadillac Seville Blower Motor Resistor Parts and Q&A

Q: How to replace the blower motor resistor on 2000 Cadillac Seville?
A: To change blower motor resistor, one needs to unfasten the console trim plate, unplug the electrical connector, and also remove the rear fasteners then unscrew the resistor. Installation To install, pre-set the new resistor, screw it in with the rear studs, re-connect the electrical connector, and screw the console trim plate back in.