OEM 2000 Chevrolet Camaro Battery Cable

2000 Chevrolet Camaro Battery Cable Parts and Q&A

• Q: How to remove and reinstall the positive Battery Cable from a battery and related components on 2000 Chevrolet Camaro?

  A: First thing to do in order to remove the positive cable is to disconnect the battery. Open the positive cable cap and take the positive cable off the fuseblock stud nut, then take off the positive cable from fuseblock stud. Next, pull the positive cable from the rosebud clip at Power Steering Reservoir, followed with pulling the wiring harness ground bolt, radio frequency (RF) ground strap, and cruise control ground lead from the front rail. Proceeds to the generator, sliding the boot down, exposing the positive terminal stud, removes the positive cable nut on the generator input stud, then removes the positive cable. Remove the positive cable rosebud clip from the engine lift bracket and the clips from the cooling fans. Lift and support the vehicle in a proper manner. Raw away rf ground nut, harness clamp from stud, rf ground strap. Take off the starter motor shield after which if the positive cable deserve to be discarded, expose the positive cable to starter motor nut, unscrew it and withdraw the positive cable from the harness conduit. In terms of installation begin by joining the positive cable with the harness conduit and then bolt it onto the starter motor nut and tighten it to 10 n.m (89 lb in). Reinstall the starter motor shield, the positive/negative cable to the engine mount stud. Make sure to install the rf ground strap, harness clamp and tighten the positive cable rf ground nut to 25 n.m 18 lb ft. Put back the wiring harness bolt, rf ground strap and cruise control ground lead back to the front rail and tighten the wiring harness ground bolt to 12 n.m (106 lb in). AT the generator, the positive cable is connected to the stud, with the securing of the positive cable nut to the generator output stud at 22 n.m (16 lb ft), with the sliding off the boot on the generator output stud. Lastly, connect the positive cable to fuseblock stud and secure the positive cable to fuseblock stud nut at 14 n.m (10 lb ft) then closed the positive cable cap and reinstall the battery.