OEM 2000 Chevrolet Monte Carlo Hood Cable

2000 Chevrolet Monte Carlo Hood Cable Parts Questions & Experts Answers

• Q: How to replace the Hood Cable for the Primary Latch Release on 2000 Chevrolet Monte Carlo?

  A: Start the Hood Cable replacement process by blocking the Hood Latch so it will not lock during installation of the new cable. A preventive step includes blocking the Hood Latch before you disconnect the hood release cable from the Hood Latch bracket by pressing the retainer until it comes loose. The 3.4 l requires air cleaner removal (Air Cleaner Assembly Replacement 3.4 L) while the 3.8 l requires the same air cleaner service (Air Cleaner Assembly Replacement 3.8 L). To continue with the repair remove the retainers from the upper tie bar and engine compartment side rail before detaching the cable from the hood release handle (Hood Cable Handle Replacement). Carpets need pulling aside until you reach the cable which must end inside the passenger area where you will tie it to the hood release cable end for easier installation. A small flat-bladed tool is needed to extract the dash grommet while you remove the hood release cable. Tie the wire or string to the new cable before you pull it through the dash to seat the grommet then install the grommet. After reattaching retainers to the side rail and tie bar install the Hood Latch cable then reinstall the air cleaner (refer to Air Cleaner Assembly Replacement 3.4 L or 3.8 L instructions). Install the cable to the hood release handle then restore the carpet while removing the block from the Hood Latch and testing the cable functionality before closing the hood. Finally, close the hood.