OEM 2000 Chevrolet Monte Carlo Rod Bearing

2000 Chevrolet Monte Carlo Rod Bearing Parts Questions & Experts Answers

• Q: How to replace the connecting rod bearing on 2000 Chevrolet Monte Carlo?

  A: To change the connecting Rod Bearing, take off the Oil Pan, and set the connecting rod to be worked on at bottom dead center (BDC) by rotating the Crankshaft. Use the j 41507 (Connecting Rod Assembly Guide) to remove connecting rod cap bolts as well as the lower connecting Rod Bearing disassembly the cap from the relating rod making certain to keep those bearing with the assembly connecting rod and cap for reassembly. Then, take off the lower connecting Rod Bearing from the connecting rod cap and attach the j 41507 to the connecting rod through which you push up the connecting rod and the Piston to be able to reach the upper connecting Rod Bearing and remove it. Clean the oil off of the bearings and check them out as well, measuring the bearing clearance as required. For installation dip connecting rod cap bolts in clean engine oil and lubricate the surface of the bearing with clean engine oil before fitting upper connecting Rod Bearing. Use the j 41507 to draw down the Piston, connecting rod, and upper connecting Rod Bearing and then j 41507 removed and install the lower connecting Rod Bearing to the connecting rod cap. Install the connecting rod cap and the connecting rod cap bolts, tightening them to 27 over n m to 20 ft. Lbs. And with the j 36660-a (Torque Angle Meter) to turn the bolts another 50 degrees. Check for binding while prying the connecting rod back and forth and adjusting the cap bolts if necessary. Measure connecting rod side clearance, install Oil Pan, and lastly check the oil pressure and leaks.