OEM 2000 Chevrolet Prizm Brake Light Switch

2000 Chevrolet Prizm Brake Light Switch Parts Questions & Experts Answers

• Q: How to service and repair the brake light switch on 2000 Chevrolet Prizm?

  A: To perform Brake Light Switch maintenance you should detach the battery negative terminal and remove the knee bolster. Start by removing the plastic retainers and ductwork system from the i/p carrier alongside the left side air ventilation parts. You need to disconnect the stoplamp switch electrical connector while removing one locknut and taking out the stoplamp switch . You can position the stoplamp switch on the brake pedal bracket and hold it in place with a single locknut before further tightening. Reposition the stoplamp until proper space is achieved then fasten the locknut to 10 nm (89 inch lbs.). Plug in the stoplamp switch electrical connector and put back the left side air outlet duct to the i/p while using the screw to fasten it. Afterward, secure the left side air ventilation duct into place with its plastic retainer. Reattach the knee bolster and plug in the negative electrical power into the battery.