OEM Chevrolet Prizm Brake Light Switch

Chevrolet Prizm Brake Light Switch Parts and Q&A

• Stoplamp Switch
  94853423
  Q: How to service and repair the brake light switch on Chevrolet Prizm?

  A:

  To perform Brake Light Switch maintenance you should detach the battery negative terminal and remove the knee bolster. Start by removing the plastic retainers and ductwork system from the i/p carrier alongside the left side air ventilation parts. You need to disconnect the stoplamp switch electrical connector while removing one locknut and taking out the stoplamp switch . You can position the stoplamp switch on the brake pedal bracket and hold it in place with a single locknut before further tightening. Reposition the stoplamp until proper space is achieved then fasten the locknut to 10 nm (89 inch lbs.). Plug in the stoplamp switch electrical connector and put back the left side air outlet duct to the i/p while using the screw to fasten it. Afterward, secure the left side air ventilation duct into place with its plastic retainer. Reattach the knee bolster and plug in the negative electrical power into the battery.
• Stoplamp Switch
  94860112
  Q: How to replace the rear brake light switch on Chevrolet Prizm?

  A:

  Start switch replacement by taking out the IP drivers knee bolster reinforcement. The first step requires removal of the plastic retainer followed by the left I/P outer air outlet duct. You must disconnect the cruise control release switch electrical connector before loosening the locknut on the same switch. Unscrew the cruise control release switch counterclockwise until it comes loose from the clutch pedal bracket. You must mount the new cruise control release switch into the clutch pedal bracket by screwing it clockwise and tightening it with the locknut. Return the cruise control release switch electrical connector to power before reinstalling the left I/P outer air outlet duct with its plastic retainer. The last step includes reinstalling the IP drivers knee bolster reinforcement.