OEM Chevrolet Prizm Wiper Switch

Chevrolet Prizm Wiper Switch Parts and Q&A

• Multifunction Switch
  94857234
  Q: How to replace the Windshield Wiper Switch on Chevrolet Prizm?

  A:

  The sir system must be deactivated before starting the windshield washer switch replacement. You can access and remove the lower trim cover screw plus the two lower trim cover screws beneath the Steering Wheel by rotating the wheel without removing it from its position. Unscrew and peel away the Steering Column lower trim before removing the Steering Column upper trim cover screw and full plate. When base damage exists you need to swap entire turn signal headlamp and windshield washer unit. Pull the wiper washer switch electrical cable before removing its two screws and switch. Insert the wiper/washer switch onto the Steering Column and hold it with both screws securely. Reattach the wiper/washer electrical connector before installing the upper Steering Column trim and fixing it with its screw. Put on the Steering Column lower trim and fasten it using the three screws before turning on the sir functionality.
• Wiper Switch
  94857237
  Q: How to Service and Repair a Wiper Switch on Chevrolet Prizm?

  A:

  Before working on the Wiper Switch you must disable sir and remove the lower trim cover screw which hides two more screws under the Steering Wheel accessible when rotating it. Begin by detaching the lower trim cover of the Steering Column and then disconnect the upper trim cover screw and upper trim cover. Since the switch assembly needs replacement when base damage is found you must replace the turn signal headlamp and windshield washer switch at the same time. Unplug the wiper/washer switch electrical connector. Next remove its two screws and switch. After attaching the wiper/washer switch to the Steering Column apply the two screws for installation. Connect the wiper washer switch electrical plug and insert the upper trim cover over the Steering Column. Secure the viewing window with one screw. Secure the last part of the assembly by placing the Steering Column lower trim cover and using three screws. Reactivate the sir system after working ends.