OEM 2000 Chevrolet Tracker Clutch Slave Cylinder

2000 Chevrolet Tracker Clutch Slave Cylinder Parts and Q&A

• Q: How to service and repair the Clutch Slave Cylinder on 2000 Chevrolet Tracker?

  A: A proper Clutch Slave Cylinder service starts by properly supporting the vehicle while it is raised. Drain the hydraulic system before pulling out the clutch fluid hose bolt and washer on the clutch fluid hose. The service professional must separate the clutch actuator cylinder bolts before extracting the clutch actuator cylinder from its position within the transmission unit. The tip of the new clutch actuator cylinder demands a small grease application with either non-gm p/n 1051344 lubricant or an equivalent. Maintain a proper fitment of the clutch actuator cylinder onto the transmission by properly applying fastener service procedures. Fasten the clutch actuator cylinder using bolts afterward tighten them to 16 nm (11.5 ft. Lbs.). The clutch actuator cylinder hose bolt requires installation between the clutch actuator cylinder and its fluid line. Tighten the line bolts to 23 nm (17 ft. Lbs.). Perform a hydraulic clutch bleeding procedure at the completion of the installation.