OEM 2000 Chevrolet Venture Radiator fan

2000 Chevrolet Venture Radiator fan Parts and Q&A

• Q: How to replace the radiator fan on 2000 Chevrolet Venture?

  A: Start by disconnecting the Radiator fan harness electrical connector when the ignition is switched off to replace the electric Radiator fan. Start by partially loosening the bolts on the engine mount strut at the engine end before disconnecting all bracket brace bolts from the upper radiator support. Finally, rotate the brackets to the rear direction. Start by removing the air cleaner together with its duct assembly then disconnect the Radiator fan shroud bolts from the housing. To enhance access remove the transmission oil cooler lines from their mounting brackets after detaching those brackets. Then move the wiring harness near the upper radiator support. You must remove both radiator fans as well as the Radiator fan shroud. The wiring harness should be repositioned before installing the radiator fans with the Radiator fan shroud along with tightening the Radiator fan shroud bolts to 6 nm (53 inch lbs.). Both transmission oil cooler lines should be attached to their retainers before reinstalling the air cleaner assembly alongside its duct. The next step installs engine mount strut bracket brace bolts at the upper radiator support before returning the struts and brackets in place while you tighten the engine mount strut bolts at the engine side. Reconnect the Radiator fan harness electrical connector as the last step.