OEM 2001 Chevrolet Corvette Oil Filter

2001 Chevrolet Corvette Oil Filter Parts Questions & Experts Answers

• Q: How to replace the engine oil and oil filter on 2001 Chevrolet Corvette?

  A: You can start your engine oil and Oil Filter replacement by opening the hood before you remove the oil fill cap. Support the vehicle properly before draining engine oil from the oil pan via the Drain Plug and place the oil into an acceptable container while waiting until all fluid is drained. Before proceeding to drain the oil from the filter opening place the engine Oil Filter into the drain pan after unscrewing it from the engine block. Check that the filter seal does not remain adhered to the block. Apply clean oil onto the engine Oil Filter gasket and mount the filter properly to the engine block while tightening the fastener to 30 nm (22 ft. Lbs.). Clean the oil pan drain hole then install the Drain Plug by tightening it to 25 nm (18 ft. Lbs.). After dropping the car down fill the engine compartment with correct oil amounts using proper engine fluid. After 3 minutes of running the engine you should raise the vehicle to check for oil leaks in both the Oil Filter and oil pan Drain Plug areas. It is essential to wait for three minutes until engine temperature drops before lowering the vehicle to the ground. To continue check the engine oil level before filling it to maximum capacity on the oil level indicator (dipstick) then reinstall the cap followed by hood closure. Afterwards reset the engine oil life monitor. Any form of engine oil additive should be completely avoided in corvette engines.