OEM 2001 Chevrolet Venture ABS Control Module

2001 Chevrolet Venture Parts Questions & Experts Answers

• Q: How to replace the ABS Control Module on 2001 Chevrolet Venture?

  A: The first step to replace the ABS Control Module requires flipping the ignition switch to off position to shield equipment from harm. Pull the air cleaner housing out from the engine compartment following removal of the red locking tab on connector lock tab. A user should use their hand to press down on lock tab while sliding connector cover to move into an open position to disconnect the ABS Control Module harness connector. The assembly needs cleaning of all dirt before removing the master cylinder mount nuts for placing the master cylinder to the side while keeping brake pipes connected. When removing the four ABS Control Module to bpmv screws avoid using tools to separate them since this will result in damage to both bpmv surface and solenoid valves. A soft action should be used for removing the ABS Control Module from its position on the bpmv. Apply alcohol on the bpmv surface with a clean rag before installing the ABS Control Module onto the bpmv and using the four screws to fasten it while tightening the screws to 5 nm (44 inch lbs.). Install the master cylinder back onto the Brake Booster while securing its mount bolts to 25 nm (18 ft. Lbs.). A technician should install the ABS Control Module connector harness, activate the lock tab and move the sliding connector to its locked position followed by inserting the red locking tab. Complete the process by reinstalling the air cleaner housing then activate the ignition switch to run without engine start followed by performing the diagnostic system check - abs.