OEM 2003 Cadillac DeVille Antenna Cable

2003 Cadillac DeVille Antenna Cable Parts Questions & Experts Answers

• Q: How to Replace an Antenna Cable on 2003 Cadillac DeVille?

  A: You can start the Antenna Cable replacement process by taking off the floor console if your vehicle has dts or by removing the instrument panel (IP) center compartment from base deville and dhs models. You need to remove the left front seat first then proceed with removing the left front and left rear carpet retainers. The install process needs removal of the center pillar garnish molding and rear seat back and left rear sail panel. First disconnect the radio antenna extension cable from the Antenna Cable before you lift the front along with rear carpet sections on the left side to see the vehicle wiring harness. Fan out the vehicle harness conduit cover from its position and cut the antenna coaxial cable at the rear seat section of the harness which is near the rear fuse block. Cut the Antenna Cable end-off near the rear shelf area of the wiring harness after disconnecting it from the antenna module . During installation use the ip to feed new coaxial Antenna Cable through the wiring harness conduit then reinstall the vehicle harness conduit cover at the rear seat location. Attach the carpet area over the vehicle wiring harness and guide the Antenna Cable towards the antenna module to make its connection. The antenna module wiring harness requires reconnection of the radio Antenna Cable along with repositioning of clips to secure the Antenna Cable within the electrical rear seat area so it does not affect seat back or bottom installation. After connecting the radio Antenna Cable to the radio extension cable you should reinstall the floor console on dts vehicles or the instrument panel (IP) center compartment for base deville and dhs models, followed by the left front seat then the left rear sail panel, center pillar garnish molding, left front carpet retainer, left rear carpet retainer and finally the rear seat back.