OEM 2004 Cadillac DeVille Antenna Cable

2004 Cadillac DeVille Antenna Cable Parts Questions & Experts Answers

• Q: How to replace the Antenna Cable for the digital radio with RPO Code U2K on 2004 Cadillac DeVille?

  A: The replacement process for coaxial cables affecting digital radio functionality with u2k rpo begins with removing the rear sail panels and rear assist handles before lowering the rear section of the headliner while being cautious about avoiding headliner damage from bending. Rule out the Antenna Cable from its clips while removing the foam tape from the point where the Antenna meets the am/fm Antenna module. Separate the Antenna connectors from the radio Antenna before attaching wire or string to the Antenna Cable end. Remove the left rear trim panel and disconnect the Antenna Cable connection to the digital receiver. Detach the Antenna Cable from its clips then harness before pulling it into the rear compartment until you extract both wire and string from the cable so you can remove it from the vehicle. Start the installation by joining a wire or string to the new cable end before pulling it safely through the rear shelf towards the passenger area where you can remove the wire or string. Starting at the digital receiver secure the Antenna Cable into place while utilizing hold-down clips which reside in the rear compartment. Attach the Antenna connectors to the digital radio Antenna before placing back the left rear compartment trim panel and wrapping the connector with foam tape. At the initial stage, install the Antenna Cable connection above the am/fm Antenna module before you attach the Antenna Cable to roof and third pillar locating clips. Next step up is to align the headliner properly to the roof panel and finish off with rear assist handle and rear sail panel reinstallation.