OEM 2003 Cadillac Seville Antenna Cable

2003 Cadillac Seville Antenna Cable Parts Questions & Experts Answers

• Q: How to Replace an Antenna Cable on 2003 Cadillac Seville?

  A: Begin Antenna Cable replacement by taking off the Center Console with all left front seat components including left front carpet retainer and left rear carpet retainer and center pillar garnish molding and rear seat back and left rear sail panel. Remove the vehicle harness conduit cover after exposing the vehicle wiring harness by pulling up the front and rear carpet sections on the left side of the vehicle using the antenna extension cable detachment from Antenna Cable as your starting point. Cut the antenna coaxial cable at the rear seat location of the harness beside the rear fuse block and sever the radio antenna coaxial cable connection from the antenna module while making sure to trim only the Antenna Cable. Cut the back end of the Antenna Cable near its rear shelf area mount location on the harness. Disconnect the Antenna Cable off both mount positions above the rear shelf panel. To complete the installation feed the new coaxial Antenna Cable through the wiring harness conduit from ip to rear seat area then install the vehicle harness conduit cover. Put the carpet back in position over the vehicle wiring harness and lead the Antenna Cable to the antenna module for connection. The radio Antenna Cable requires reconnection to the antenna module wiring harness with clips you must attach securely to the electrical wiring harness found in the rear seat zone where the installation must be free from seat removal procedures. Mark the radio Antenna Cable for connection to the radio extension cable before reinstalling Center Console and front and rear seat components along with left rear sail panel and center pillar garnish molding and carpet retainers.