OEM 2003 Chevrolet SSR Battery Cable

2003 Chevrolet SSR Battery Cable Parts and Q&A

• Q: How to replace the positive battery cable from the junction block to the engine on 2003 Chevrolet SSR?

  A: When replacing the battery positive cable running from the junction block to the engine start with vehicle elevation followed by removal of rear battery cover screws and cover. Start by disconnecting the negative Battery Cable and after that lower the vehicle. Locate the positive Battery Cable on the junction box then take out the nut followed by the bolt that holds the positive cable to the electrical center. Proceed by taking out the positive cable attachment from the generator rear portion then lift the vehicle before taking off the Starter mounting nut. First detach the positive cable assembly from wire looms before extracting it downwards from below the vehicle. To install start by putting the positive cable assembly into the vehicle from the bottom while attaching it to the wire looms according to service precautions. Secure the positive cable Starter nut by torquing it to 9 n.m (80 lb in). After lowering the vehicle position the positive cable at the generator's rear section while tightening the nut to 9 n.m (80 lb in). Reposition the positive cable bolt at the electrical center and tighten its nut to 9 n.m (80 lb in) before you install both cable pieces and fasten the nut in the junction box to 6 n.m (53 lb in). Complete the task by installing the rear battery cover followed by tight nut torque at 10 n.m (89 lb in) production. Afterward, lower the vehicle.