OEM 2005 Cadillac DeVille Wheel Bearing

2005 Cadillac DeVille Parts Questions & Experts Answers

• Q: How to service and repair the wheel bearing and hub with RPO FE1 and FE3 on 2005 Cadillac DeVille?

  A: Begin servicing and repairing wheel bearings and hubs of vehicles with rpo fe1 and fe3 by properly lifting and stabilizing the vehicle. Lay down the wheel and tire before you insert a flat blade into the caliper and rotor to stop the rotor from spinning. Pull out the wheel drive shaft nut and the rotor from the vehicle. To reach the front wheel speed sensor you must first disconnect its connector from the dust shield. Use front/rear spindle remover tool part number j 28733-b to unscrew Wheel Bearing and hub holding bolts before detaching Wheel Bearing and hub unit from drive axle. When working on the components follow these steps: the Wheel Bearing needs cleaning while handling the abs sensor wire must be avoided. Put the dust shield in place without damaging the bearing outboard lip seal and put the Wheel Bearing along with the hub onto the drive axle. Use a small grease amount to seal the steering knuckle bore. Thread on the drive axle nut to push into position the Wheel Bearing and hub assembly before using the Wheel Bearing and hub bolts at 130 nm (96 ft. Lbs.). Reattach the front wheel speed sensor connector to its shell on the dust shield and proceed to fit the rotor in place. Slide the large flat device through the caliper and rotor to stop rotation. Then install the wheel drive shaft nut at 160 nm (118 ft. Lbs.). After completing these steps, put on the tire and wheel before lowering the vehicle into position.