OEM 2006 Chevrolet HHR Ignition Lock Cylinder

2006 Chevrolet HHR Ignition Lock Cylinder Parts and Q&A

• Q: How to replace the ignition lock cylinder on 2006 Chevrolet HHR?

  A: Starting the Ignition Lock Cylinder change requires disconnecting the negative cable and disabling sir functionalities. Begin by removing steering column trim covers along with any present theft deterrent control module. Adjust the Ignition Lock Cylinder to the run position. There are two retainers on the Ignition Lock Cylinder; to extract the housing component users need to compress both retainers. Insert a small allen wrench tool through the lock housing access hole to push the first retaining pin backward thus slightly moving the lock cylinder from its position. The second retainer requires you to push through the lock housing access hole to allow backward cylinder movement. Pull the lock cylinder enough to find hole before depressing the second retainer to continue. The ignition cylinder should release from the housing; repeated movements of the ignition cylinder will help you locate the correct position for the retainer. Extract the lock cylinder out of the lock housing. Put the new lock cylinder into the run position then insert it into the lock housing while making sure it rotates correctly. Follow the installation of theft deterrent control modules if present with steering column trim cover replacement. Activate the sir system after reconnecting the negative Battery Cable. Programming of the theft deterrent control module should be completed as the final step if the vehicle has this system.