OEM 2006 Chevrolet Uplander Fuse Box

2006 Chevrolet Uplander Parts Questions & Experts Answers

• Q: How to replace the underhood fuse box on 2006 Chevrolet Uplander?

  A: The process to install a new underhood electrical center starts by opening the hood and supporting it before disconnecting the negative Battery Cable from the system. Before beginning disconnect the positive Battery Cable nut and remove the cable from the positive terminal stud. The base of the accessory wiring junction block assembly requires its cover to be removed. Users should unlock the 2 tabs from the base electrical center section before slowly pulling each accessory junction block side free from the main body connectors to expose the lower connector points. A hook tool should be used to lift the connector upwards which will lock the connectors into position at the base. All three lower harness connectors need to be correctly staged into the lower base section before installing the new assembly. To secure the installation verify that every connector attaches with light force to the base by examining if its side tabs lock into place. Set the new underhood accessory wiring junction block assembly above the base while ensuring correct alignment of locator pins before securing it with downward force. The assembly should be checked for lower base lockage through examination of its two outer locking tabs. The positive Battery Cable should then receive installation through the stud before tightening its retaining nut to 10 n.m (89 lb in). Complete the procedure by placing the underhood electrical center cover on top of the electrical center base and reconnect the negative Battery Cable before closing the hood and re-doing the power sliding door re-initialization.