OEM 2006 GMC Envoy Ride Height Sensor

2006 GMC Envoy Ride Height Sensor Parts and Q&A

• Q: How to replace the front Ride Height Sensor on 2006 GMC Envoy?

  A: A replacement of the air spring leveling sensor requires removing the air suspension system fuse first to avoid calibration problems. Level the vehicle by parking on flat ground and monitor each tire pressure against the vehicle certification label specifications. Examine all components of the air suspension system to identify damages and defects. Livestock the vehicle while you remove the rear tire along with wheels from the vehicle. The rear axle needs to maintain its proper d height according to trim height specifications after receiving support. Unplug the electrical connector as well as remove the sensor mounting bolts to take out the sensor after separating its link from the Control Arm. To install the sensor link must be attached to the upper Control Arm followed by fastening the sensor to the frame with bolts tightened to 8 nm (71 inch lbs.) and perform a sensor alignment test before removing the locating pin. Connect the electrical connector then remove the rear axle support before reattaching the rear tire with its wheels. Finally raise the vehicle before inserting the air suspension system fuse. You should turn on the vehicle and operate it for 1 minute to prove the air spring leveling system operative before conducting a d height measurement according to the trim height inspection procedure.