OEM 2007 Cadillac SRX Washer Reservoir

2007 Cadillac SRX Washer Reservoir Parts and Q&A

• Q: How to replace the washer reservoir on 2007 Cadillac SRX?

  A: First open the hood and remove the cap from washer solvent container to perform replacement. Begin by removing both the lower air deflector and the front bumper fascia then unplug the passenger side headlamp for lhd or the driver side headlamp for rhd configurations. Remove the washer fluid before disconnecting its hoses from the washing pumps. Detach the container electrical connector retention clip while also separating electrical links from washer pumps and washer solvent level sensor. Unfasten the container and direct its fill neck down through the radiator support until you can fully remove the system from the vehicle. Install the washer pumps with washer level sensor into the new washer solvent container as you put the horizontal bracket and container cap on it. Feed the new container's filler tube up through its radiator support space and lock the electrical connection piece. Insert the solvent container fasteners into place and tighten them to 6 n.m (53 lb in). Plug the washer hose and electrical wires into their correct positions on each Washer Pump and the washer solvent fuel gauge. Put back the headlamp unit along with the front bumper and lower air deflector. Fit the washer solvent container filler neck over the upper tie bar and fasten it with a bolt at 6 n.m torque. Use washer solvent to fill the container and seal it with the cap while closing the hood.