OEM 2007 Chevrolet Colorado Brake Disc

2007 Chevrolet Colorado Brake Disc Parts and Q&A

• Q: How to replace the Brake Disc on 4WD on 2007 Chevrolet Colorado?

  A: Check the brake fluid level in the brake master cylinder reservoir before replacing the Brake Disc. If the fluid is mid-way between high and low marks, no fluid has to be drained out. But if the fluid level is above mid-way, use a proper tool to remove fluid until it reaches the mid-way mark. Place wood blocks under the Wheel Hub/speed sensor assembly to support the Brake Disc assembly. After that, disassemble the Steering Knuckle and Wheel Hub/speed sensor from the disc. Take off the Brake Disc bolts from the Wheel Hub/speed sensor and disconnect the Brake Disc from the wheel bearing unit. Clean both mating surfaces for installation later. Place the wheel bearing/hub on top of the Brake Disc then install the wheel bearing/hub mounting bolts. Use a criss-cross pattern to tighten them first to 20 n.m (15 lb ft) and next to 110 n.m (81 lb ft). This process should be carried out on a flat surface without air tools. Install the Steering Knuckle assembly along with the wheel bearing/hub assembly and the Brake Disc on the vehicle. Then put the vehicle back down and test the brake system to avoid any equipment problems.