OEM 2007 GMC Envoy Shift Cable

2007 GMC Envoy Parts Questions & Experts Answers

• Q: How to replace the Automatic Transmission Range Selector Shift Cable on 2007 GMC Envoy?

  A: Start by placing the vehicle into park position and then raising the car before performing the Shift Cable replacement. Begin by removing the transmission range selector lever ball stud end from the Shift Cable and then disconnect its retainer segment. The first step involves breaking the bracket-retained Shift Cable free before extracting it from the floor panel retainer and additionally disengaging the retainers located on 4wd transfer cases. Insert the grommet cable through the floor panel while lowering the vehicle. Start by uninstalling the console and both the driver's side front mat and carpeting. Disembark the Shift Cable end from the ball stud on the floor control and remove the cable from the floor shift control assembly. Start by removing the Shift Cable tape and grommet from the panel before taking off the Shift Cable from the automobile. To install the cable service the floor panel first and guide it down before fitting the grommet and then joining the Shift Cable to the floor shift control assembly and the floor control ball stud. The driver's side front mat and carpet should be installed first followed by the console. Raising the vehicle gives you access to install the cable either to floor panel retainers or the Transfer Case retainers when using a four-wheel-drive system. The Shift Cable requires attachment to its bracket then a secure connection of the retainer to the cable. To finish the procedure connect the Shift Cable to the transmission range selector lever ball stud while performing Shift Cable adjustments and then lowering the vehicle to conduct proper operation checks.