OEM GMC Envoy Shift Cable

GMC Envoy Shift Cable Parts Questions & Experts Answers

• Shift Control Cable
  15785087
  Q: How to replace the automatic transmission shift cable on GMC Envoy?

  A: The first step to replace the Shift Cable is to position the vehicle in park followed by suitable support of the car to prevent pulling on the cable boot end. Use a flat bladed tool to disconnect the Shift Cable from the transmission shift lever ball stud by leveraging between the Shift Cable end and shift lever. To detach the cable you must first take out its retainer then extend the locking tabs so they free it at the bracket point. Lower the vehicle as you push the cable grommet through the floor panel. The driver's side carpet requires lifting upward to view the Shift Cable while accessing it through the left hinge pillar trim panel. Circumvent the Shift Cable retainer at the lower dash panel while using a flat-bladed tool to remove the Shift Cable from the transmission shift lever ball stud. The retainer should be removed from the cable before pushing the locking tabs into the steering column bracket and extracting the cable from the vehicle. Push the Shift Cable down through the floor panel then seat the cable grommet before directing the cable through dash mat and attaching the retainer to the lower dash panel. Secure the cable installation at the steering column bracket through retainer attachment. Put the cable end onto the shift lever ball stud and afterward reset the driver's side carpet. Check under the accelerator pedal for any type of binding then put back the left hinge pillar trim panel. After installment of the Shift Cable to its bracket it should be fastened with a retainer. During the installation of a new cable replace the primary lockout pin with a new one before you adjust the Shift Cable then complete by lowering the vehicle.