OEM GMC Envoy Flywheel

GMC Envoy Flywheel Parts and Q&A

• Drive Plate
  12576272
  Q: How to service and repair the engine flywheel on GMC Envoy?

  A:

  Start the engine Flywheel servicing and repair work by obtaining a torque angle meter which is tool number j 36660-a. Start by taking out the transmission while paying attention to the engine Flywheel direction and position before dismantling. Begin by removing both the Flywheel bolts next to the Flywheel itself. A complete inspection followed by cleaning operation should take place for the Flywheel. Usage of threadlock gm p/n 12345493 (Canadian P/N 10953488) rated should be applied to the new Flywheel bolts before installation. Fasten and tighten the fresh bolts which secure the Flywheel by applying torque to 25 nm (18 ft. Lbs.) using a precise order. Follow the torque angle meter procedure (J 36660-A) to perform an additional 50° screw torque on the bolts. Finally, reinstall the transmission.
• Drive Plate
  12654640
  Q: How to replace the engine flywheel on GMC Envoy?

  A:

  The first step for replacing the engine Flywheel involves extracting the transmission from its place. Observation of engine Flywheel position should happen before taking it out from its location. Follow the order of removing Flywheel bolts followed by the removal of the Flywheel itself. A complete inspection along with cleaning must occur before accepting the Flywheel into service. Threadlock should be applied to the bolts of a new Flywheel before installation. Install the Flywheel into position by using the new bolts for securing while tightening with a sequence of 25 nm (18 ft. Lbs.) torque application. The torque angle meter (J 36660-A) should be used to extend bolt tightening to a total of 50 degrees before transmission reinstallation.