OEM 2008 Cadillac Escalade ESV ABS Control Module

2008 Cadillac Escalade ESV ABS Control Module Parts and Q&A

• Q: How to Replace the ABS Control Module on 2008 Cadillac Escalade ESV?

  A: Raising and supporting the vehicle is the first step toward ABS Control Module replacement with part number JL4. First discard all dirt and debris from the ABS Control Module unit and brake pressure modulator valve (BPMV) before starting any component removal procedure. The installation of new screws replaces the ABS Control Module to BPMV screws because their reuse is prohibited. Denatured alcohol should be used to clean the ABS Control Module and BPMV before disconnecting the ABS Control Module electrical connector. Use caution when removing the ABS Control Module from BPMV by pulling it out after discarding both ABS Control Module to BPMV screws. Installation requires proper alignment of the ABS Control Module with the BPMV while placing the new gasket onto the BPMV and positioning the brake pressure switch without pressure on the components. Offer the ABS Control Module with square alignment to the BPMV surface before installing four new ABS Control Module to BPMV screws in an X pattern at 3 N.m torque. Plug in the ABS Control Module electrical connector. Run the programming procedures when installing a new ABS Control Module. The appropriate automated BPMV bleeding procedure must be used to finish the process.