OEM 2010 Cadillac DTS Power Steering Reservoir

2010 Cadillac DTS Parts Questions & Experts Answers

• Q: How to replace the Power Steering Reservoir on 2010 Cadillac DTS?

  A: Removing the Power Steering Reservoir from the vehicle begins with unscrewing mounting bracket bolts from the mounting bracket assembly before extracting the mounting bracket assembly off the pump unit. The J-42649 Power Steering Pump Reservoir Clip Remover will extract the retaining clips from the reservoir assembly while allowing the technician to remove the reservoir from the hydraulic pump housing. Remove the O-ring seal which is found inside the reservoir before discarding it. Ensure proper tightening of TORX(R) head bolts on the hydraulic pump housing to 20-25 Nm (15-18 lb ft). After tightening the valve bore plug to 50-60 Nm (37-44 lb ft) install the new O-ring seal into the reservoir by lubricating it with power steering fluid. The mounting hole on the reservoir needs to match exactly with the opening of the housing assembly so it avoids any damage and you can safely join the reservoir assembly to the hydraulic pump housing. Fasten the retaining clip completely onto the reservoir assembly before hammer tapping the retaining clips finally secure the pump to the mounting bracket assembly by tightening its bolts to 28-38 Nm (21-28 lb ft).