OEM 2010 Cadillac STS Air Bag Sensor

2010 Cadillac STS Parts Questions & Experts Answers

• Q: How to replace the Air Bag Sensor in the Front End on 2010 Cadillac STS?

  A: To replace the inflatable restraint front end sensor, you disable the sir system. Ohm test - turn car off, measure the ohms on drain plugs, and compare the reading todocumentation/. Remove the connector position assurance (CPA) from the wiring harness connector for the inflatable restraint front end sensor and disconnect the wiring harness connector from the front end sensor, referencing the fact that the front end sensor mounting fastener is left-hand threaded. Loosen front end sensor of the mounting fastener at the upper tie bar and remove the front end sensor from the upper tie bar. For installation, degrease the mounting surface of any dirt, grease or impurity, place the sensor flat with arrow facing the front of the vehicle, and mount using the fasteners to over 9 nm (80 lb. In.). Connect the harness wiring connector with front end sensor, install cpa to the wiring-harness connector, repos the Radiator, and install Radiator sight shield. Finally, enable the sir system.