OEM 2010 Chevrolet Corvette Oil Filter

2010 Chevrolet Corvette Oil Filter Parts Questions & Experts Answers

• Q: How to replace the engine oil and oil filter in a 6.2L engine on 2010 Chevrolet Corvette?

  A: After opening the hood, start engine oil and Oil Filter replacement by removing the oil fill cap followed by the front compartment lower noise shield. You need to take out the oil pan Drain Plug to empty engine oil into its proper storage container. Extract the engine block's engine Oil Filter before proceeding with the installation. Make sure to remove all remnants of the previous Oil Filter seal before installing your new filter. If it remains, remove it. Apply clean engine oil to the Oil Filter seal before you mount the filter onto the engine block and torque it to 30 nm (22 lb ft). After draining the engine oil from the oil pan Drain Plug the technician should reinstall this plug while tightening it to 25 nm (18 lb ft) torque before returning the vehicle to the ground. Any form of engine oil additives should never be used in corvette engines. Use the correct engine oil amount alongside its specifications while following usa and canadian fluid capacity and lubricant guidelines. The engine startup requires leak checking followed by shutting down and an oil level confirmation. After resetting the engine oil life monitor, put on the oil fill cap and close the hood for installation completion.