OEM 2010 Chevrolet HHR Rack and Pinion Boot

2010 Chevrolet HHR Parts Questions & Experts Answers

• Q: How to replace the Rack and Pinion Boot on 2010 Chevrolet HHR?

  A: First of all in order to replace the steering gear boot undo the driving side outer Tie Rod End. Next, remove the Rack And Pinion inner tie rod nut and trash it, then remove the outer steering gear boot clamp. Cut away and remove the inner guide of the steering gear boot clamp. After removing the boot, check the inner tie-rod for any signs of corrosion or contamination; otherwise, replace steering gear if none is found. After the removal of the steering gear boot from the steering gear, put in a new inner steering gear boot clamp attached to the boot steering gear boot which should be clean and free of dirt as well as the steering gear should be clean and free from dirt as well and the Rack And Pinion inner tie rod. Put grease from the steering gear boot service kit to the stated locations and ensure that the steering gear boot sits aptly in the groove on the steering gear. Mount the steering gear boot on the steering gear, and then crimp the inner steering gear boot clamp with the aid of the keystone clamp pliers (J 22610). Install new outer steering gear boot clamp, then new Rack And Pinion inner tie rod nut, and then install Rack And Pinion outer Tie Rod End. The first toe at the front should also be adjusted if necessary.