Other Name: Actuator, Air Conditioner Control; HVAC Heater Blend Door Actuator; HVAC Blend Door Actuator; Actuator; Actuator, A/C Vacuum Control; Actuator, A/C Control
Replaces: 16164972
Warranty: This genuine part is guaranteed by GM's
factory warranty.
Fits the following Vehicles:
1997-2005 Buick Park Avenue | Base, Ultra | 6 Cyl 3.8 L GAS
Other Name: Actuator, Air Conditioner Control; HVAC Heater Blend Door Actuator; HVAC Blend Door Actuator; Temperature Door Actuator; Switch; Controller; Actuator; Actuator, A/C Vacuum Control; Actuator, A/C Control
Replaces: 16163982
Warranty: This genuine part is guaranteed by GM's
factory warranty.
Fits the following Vehicles:
1997-2005 Buick Park Avenue | Base, Ultra | 6 Cyl 3.8 L GAS
Other Name: Actuator, Air Conditioner Control; HVAC Heater Blend Door Actuator; Actuator, A/C Control
Replaces: 52474845
Warranty: This genuine part is guaranteed by GM's
factory warranty.
Fits the following Vehicles:
1997-2005 Buick Park Avenue | Base, Ultra | 6 Cyl 3.8 L GAS
Buick Park Avenue Blend Door Actuator
Our website offers an extensive catalog of genuine Buick Park Avenue Blend Door Actuator at unbeatable prices. Every OEM Buick Park Avenue Blend Door Actuator comes with a manufacturer's warranty, an easy return policy, and rapid delivery service. Don't miss out on this great opportunity!
Buick Park Avenue Blend Door Actuator Parts Questions & Experts Answers
Q: How to replace the Air Inlet Blend Door Actuator on Buick Park Avenue?
A: Firstly, after removing the ip compartment and the right sound insulator, it's possible to replace the air inlet actuator. Then, disconnect the Body Control Module and the hvac programmer from brackets and remove them from their brackets and bear them aside. Pull low electrical connectors off the i/p relay and junction block, unscrew bolts and nuts, rotate the relay block, then pull off the upper electrical connectors. After that, remove i/p fuse and relay junction block and remove air inlet actuator electrical connector. The air inlet actuator retaining screws should be also removed and the air inlet actuator itself. For installation, first loosen the retaining screws to the separating position as the new air inlet actuator is installed, then tighten it to 1.4 n.m (12 lb in). Retreat the electrical connector from the air inlet actuator, and attach the upper electrical connectors of the i/p fuse as well as relay block. Position the relay block and tighten it with bolts and nut at a torque of 8 n.m (80 lb in). Reconnect the lower relay block electrical connectors, re-install the Body Control Module and the hvac programmer to hang in their holders, install the right sound insulator again, and lastly, the ip compartment back.