Q: How to replace the power window switch in the rear door on Buick LeSabre?
A: Start the process by putting a flat bladed tool beneath the switch plate at its front edge then slowly move it upward to disengage from the door trim panel. Push the switch plate forward to unlock the rear retainer tabs and after that disconnect the electrical connector and remove the switch plate. Apply a small flat bladed tool to detach the switch plate while separate the window switch from its tabs and finish by removing the switch from the plate. To install replace the power window switch in its switch plate position and connect electrical connectors before inserting the rearward switch edge into the door panel and pressing the front edge to lock the retainer clip.
Q: How to Remove and Replace a Power Window Switch on Buick LaCrosse?
A: The replacement process of power window switches begins by taking out the front door trim panel. A flat-bladed tool should be used to detach the power window electrical connectors before extracting the power window switch from the trim mounting plate with this same tool. Set the newly installed switch within the mounting plate then link electrical connectors before remounting the front door trim panel.
Q: How to Safely Replace a Power Window Switch on Buick Regal?
A: Begin the Power Window Switch replacement by disconnecting the Power Window Switch to stop accidents during the express down feature which drops the door window rapidly. Before handling tools or door trim or switch plate components make sure you turn off the Ignition Switch as any connection between tool and switch might result in shorting out the system. The base of the flat surface tool should receive protective tape or coating to stop damage from reaching inside the door panel. Start by inserting a flat-bladed tool into the back of the switch plate assembly to remove both power window and door lock switch plate parts from the trim panel. The retainers will release when pressing forward with the tool. You should disconnect the electrical connectors after which you must remove the switches from their mounting plate. The installation process starts with attaching the switches to the mounting plate before connecting the electrical connectors and finally pushing the switch together with the mounting plate into the trim panel.