OEM Buick Rendezvous Rack and Pinion Boot

Buick Rendezvous Rack and Pinion Boot Parts Questions & Experts Answers

• Tie Rod Boot
  21011025
  Q: How to replace the rack and pinion boot and breather tube using the J22610 Keystone Clamp Pliers on Buick Rendezvous?

  A: To remove the Rack And Pinion Boot and breather tube from the vehicle, you can use the following tool, j22610 keystone clamp pliers (J22610). Start with dismantlement of the outer tie rod and hexagon jam nut from the inner tie rod assembly. Then remove the tie rod end clamp from the Rack and Pinion Boot and take off from the boot clamp for the Rack and Pinion Boot using side cutters and throw away the boot clamp. If there is breather tube, label its position on the gear assembly before pulling the Rack and Pinion Boot and the breather tube. Assemble by installing a new boot clamp onto the Rack and Pinion Boot and by greasing the inner tie road assembly and the rack/pinion gear assembly prior to installing the rack/pinion boot on the inner tie road assembly. Install the breather tube if available with it aligning to the mark made during the removal of the breather tube and the molded nipple of the Rack and Pinion Boot. Make sure that the Rack and Pinion Boot is free from twisting or puckering; adjust it manually if required before placing it in the gear assembly groove. Install and crimp the r a c k and pinion boot clamp using the j22610, pinch the pliers together to place the tie rod end clamp into the r a c k and pinion boot . Lastly, mount the hexagon jam nut to the inner tie rod assembly to complete the outer tie rod assembly.