Q: Can the door window motor be serviced separately, or does it require replacing the window regulator assembly on Buick Century?
A: Separate service of the Window Motor is impossible because operators need to replace the entire Window Regulator assembly. To replace the front door regulator, perform instructions from front side door Window Regulator replacement while the instructions for rear side door Window Regulator replacement should be followed for the rear door.
Q: How to replace the front door window motor on Buick LaCrosse?
A: The first step to replace the front door Window Motor includes disconnecting the Power Window Switch to stop potential harm from the express up/down feature. The first step includes taking off the front door trim panel as well as the front door water deflector. First detach the front door Window Regulator after which you need to remove both Window Regulator pieces through the access hole in the inner panel. The power Window Motor bolts must be detached at the Window Regulator position. Reinstall the Window Regulator and motor through the access opening of the inner panel while observing the fastener notice mentioned in service precautions. Seguintly tighten the power Window Motor bolts on the Window Regulator to 6 n.m (53 lb in). After putting back the Window Regulator and motor you should install the front door Window Regulator. First check the window for correct operation followed by reinstallation of front door water deflector and lastly the front door trim panel.
Q: How to replace the rear door window motor on Buick LeSabre?
A: Start replacing the rear door Window Regulator motor after trimming the door panel to reach the Window Motor fasteners which are accessible under the deflector's lower section. Before disconnecting the power Window Motor electrical connector it is vital to partially open the window since the drive could become stuck when the window is fully opened or closed. You should start by removing the power Window Motor from its attachments (W715202-S300) to the Window Regulator. The power Window Motor receives attachment to the Window Regulator by using the fasteners (W715202-S300) while tightening to 4 n.m (35 lb in). Testing the motor operation should be done following power connection and verifying the glass seal before you reinstall the water deflector and door trim panel. You must place the water deflector together with the door trim panel for completion of this step.