ChevyParts
My Garage
My Account
Cart
OEM Cadillac DeVille Air Bag Clockspring
Steering Wheel Airbag Coil- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
6 Air Bag Clocksprings found
Cadillac DeVille Air Bag Clockspring
Our website offers an extensive catalog of genuine Cadillac DeVille Air Bag Clockspring at unbeatable prices. Every OEM Cadillac DeVille Air Bag Clockspring comes with a manufacturer's warranty, an easy return policy, and rapid delivery service. Don't miss out on this great opportunity!
Cadillac DeVille Air Bag Clockspring Parts Questions & Experts Answers
- Q: How to replace the Air Bag Clockspring in the steering wheel module on Cadillac DeVille?A: In order to replace the air bag clock spring, it is necessary to disable the sir system. Remove the air bag clock spring as well as the Steering Wheel nut while marking all the alignment marks on the Steering Shaft and the Steering Wheel. Remove the Steering Wheel, proceed to take off two torx(R) head screws of the lower shroud and take off the lower shroud. Next, undo two torx(R) head screws from the upper shroud and remove the upper shroud. Detach the wire harness straps from the Steering Wheel column wire harness and remove the retaining ring and the air bag clock spring from the Steering Shaft. For installation, make sure that the wheels are straight ahead, block tooth, and centering mark on the 12 o'clock. A newly purchased sir coil assembly will be supplied pre-centered; if centering is required, refer to the instructions on the notice of the coil assembly. Position the sir coil assembly with the horn tower to the turn signal cancel cam assembly, install wave washer to upper shaft assembly and slide the coil assembly onto the race and upper shaft assembly and throw away the centering tab, then install the retaining ring, making sure it is properly seated. Secure the upper shroud by two torx(r) head screws and tighten them as 1.5 n.m (13 lb in), and then install the lower shroud and secure with two torx(r) head screws and tighten to 1.5 n.m (13 lb in). Center the tilt lever in the steering column up and slip the tilt lever handle into the steering column until it locks and feed the wiring through the Steering Wheel. In the state already mentioned, adjust the Steering Wheel to occupy a tag on the Steering Shaft and bolt it onto the shaft and tighten the bolt to 41 n.m (30 lb. Ft). Finally, install the air bag clock spring, and turn on the sir system.
Related Cadillac DeVille Parts
Cadillac DeVille Crankshaft Position Sensor
Cadillac DeVille Air Bag Sensor
Cadillac DeVille Chassis Wiring Harness Connector
Cadillac DeVille Coolant Temperature Sensor
Cadillac DeVille Door Harness Connector
Cadillac DeVille Neutral Safety Switch
Cadillac DeVille Relay
Cadillac DeVille Spark Plug
Cadillac DeVille Throttle Position Sensor
Cadillac DeVille Wiper Pivot
Cadillac DeVille Wiper Pulse Module
Cadillac DeVille Wiper Switch