In order to replace the Electronic Suspension Control Module in a Tahoe, a Yukon, or Escalade, take off the right side interior trim panel and disconnect the electrical connectors from the module, and remove the screw. Your next step is to slide the module from the bracket and remove it from the vehicle. For installation, slide in the new module in the bracket, installing the screw by using a 1.6 Nm (14 inch lb.). Make the connection of the electrical connectors to the module. Recalibrate it if you are replacing the module by connecting the scan tool to the Data Line Connector (DLC) and turning the ignition ON with the engine OFF and refer to instructions on scan tool readout. Lastly, install the right side interior trim panel.