OEM Chevrolet Avalanche 1500 Timing Cover

Chevrolet Avalanche 1500 Timing Cover Parts Questions & Experts Answers

• Timing Cover
  12633906
  Q: How to replace the engine front timing cover on Chevrolet Avalanche 1500?

  A:

  To replace the engine front cover, first, consult the tools you will need (J41476) front and rear cover alignment tool). Start by taking out the Water Pump then do the crankshaft balancer. Next, remove the oil pan-to-front cover bolts and the front cover bobs then take out the front cover and gasket, throwing away the old gasket. If necessary, clean and check the engine front cover. When installing the new cover, do not reuse the crankshafts oil seal or front cover gasket and do not seal the gasket by using any kind of sealant unless it is instructed. Apply a 5 mm (0.20 inch) length of gm p/n 12378190, or equivalent, 20 mm (0.80 inch) long sealant to the oil pan to the engine block juncture and then place the front cover gasket and cover. Ensure the front cover bolts are tightened snug without over-tightening oil pan-to-front cover bolts until snug. By using a j41476, you should center the crankshaft front oil seal, bring the tapered legs in line with the machined surfaces of the front cover. Mount the crankshaft balancer bolt until it is snug, tighten oil pan to front cover bolts to 25 nm (18 ft. Lbs.), and the engine front cover bolts to 25 nm (18 ft. Lbs.). Following the removal of the j41476, put in a new crankshaft front oil seal and now, re-attach the Water Pump.