OEM Chevrolet Aveo Neutral Safety Switch

Chevrolet Aveo Neutral Safety Switch Parts and Q&A

• Clutch Switch
  96413013
  Q: How to Adjust the Neutral Safety Switch on Chevrolet Aveo?

  A:

  Before adjusting the park/neutral position switch, one first needs to remove the negative Battery Cable. Next, remove the electric connector of the park/neutral position (PNP) switch from the wiring harness, remove the e-ring and disconnect the shift control cable from the pnp switch lever. Put off retaining nut, washer, and control lever, and unstake the lock washer and remove the nut. For installation have the pnp switch placed onto the manual valve lever shaft and temporarily install the 2 adjusting bolts. Put a new washer and nuts and tighten them to 12 nm (106 inch lbs). Install the control lever temporarily this is to turn the lever counterclockwise until it stops, turn it clockwise 2 notches before removing it. Take the groove and get it aligned with the neutral basic line and fasten the 2 bolts but tighten to a value of 5.4 nm (48 inch lbs.). Stake the nut at the end with the lock washer using a screwdriver then install the control lever, washer, and nut with tightening the nut to12 nm(106 inch lbs). Connect the control cable to the pnp switch and the pnp switch electric connector, balance the control cable, and assemble the control cable adjusting nut while tightening it to 8nm (71 inch lbs.). Lastly, connect the negative side of the battery.
• Neutral Safety Switch
  93741830
  Q: How to replace the Neutral Safety Switch on Chevrolet Aveo?

  A:

  To perform the process of replacing park/neutral position switch, you first disconnect the negative Battery Cable and park/neutral position (PNP) switch electrical connector from the wiring harness. Unscrew e-ring and disconnect the shift control cable from the pnp switch lever. Then, remove the retaining nut, washer, then control lever, then unstake the lock washer, and remove the nut with a driver. In installation, push the pnp switch on the manual valve lever shaft and insert the 2 adjusting bolts for temporary use. Replace a new lock washer and nuts and tighten to 12 nm(106lb in). Temporarily install the control lever, turn it in a counterclockwise direction until it comes to a resting place, then clockwise direction until it shifts 2 notches just before removing. Align the groove with neutral basic line, screw the bolts, and tighten unto 5 nm (44 lb in). Instead, the nut should be staked with lock washer and the helper elements, such as control lever, washer, and nut, are to be installed and tightened to 12 nm (106 lb in). Join the control cable to the pnp switch and to the pnp switch electrical connector. Adjust the control cable and install control cable adjusting nut tighteding it up to the 8 nm (71 lb in). Lastly, connect the negative Battery Cable.