How to replace the outer CV Joint and seal on Chevrolet Blazer?

To replace the wheel drive shaft outer joint and seal, collect the required tools: snap ring pliers (J 8059), seal clamp tool (J 35910), as well as drive axle clamp swage tool (J 36652), but as stated, there was no mention of any expiry date. The first step is to use a hand grinder to slice through the swage ring, and after that cut off the small boot clamp with side cutters. Slide the boot down the halfshaft bar and off the CV Joint outer race scooping out any grease. Separate the ears of the halfshaft bar retaining snap ring from the inside race of the inner race with the use of snap ring pliers (J 8059). Take off the CV Joint and boot from the halfshaft bar and discard the old boot. Use a brass drift to delicately strike and rotate the CV Joint cage in order to remove all six chrome alloy balls. Clean the inner and outer race assemblies, CV Joint cage and chrome alloy balls with cleaning solvent to make sure all the old grease and contaminants are erased, and then dry all the parts and check for wear or damage. Apply a thin layer of grease on the inner and outer race grooves, dovetail the inner race with the cage, and insert it. Install the cage and inner race into the outer race and thereafter use the brass drift to install the chrome alloy balls. Apply the pre-measured grease from the kit while packing the CV Joint boot and assembly, and put on the new small boot clamp on the CV Joint seal then slip the boot over the halfshaft bar ensuring it is torqued to 136 nm (100 ft. Lbs) using the seal clamp tool (J 35910). Make sure that the retaining ring side of the inner race CV Joint is towards the halfshaft bar and then slide the CV Joint to it and pull on to it to confirm engagement. Finally, slip the large diameter of the CV Joint boot over the CV Joint outer race and secure it tightly using the drive axle clamp swage tool (J 36652) and tighten the bolts while aligning tension and finally pull off the half heave assembly from the tool.

OEM Chevrolet Blazer CV Joint

CV Joint Axle

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

15 CV Joints found

View related parts
Chevrolet Blazer Inner CV Joint
Part Number: 84443364
$77.63 MSRP: $121.61
You Save: $43.98 (37%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: CV Joint
- Position: Inner
- Replaced by: 84444358
- Warranty: This genuine part is guaranteed by GM's factory warranty.
Fits the following Vehicles:
- 2019 Chevrolet Blazer | Base, L | 4 Cyl 2.5 L GAS
View related parts
Chevrolet Blazer Inner CV Joint, Front
Part Number: 26059677
$46.64 MSRP: $564.50
You Save: $517.86 (92%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Joint Kit, Front Wheel Drive Axle; Joint Assembly; Inner Joint; Inner Joint Assembly
- Position: Front
- Warranty: This genuine part is guaranteed by GM's factory warranty.
Fits the following Vehicles:
- 1997-2005 Chevrolet Blazer | Base, LS, LT, Trailblazer, Xtreme, ZR2 | 6 Cyl 4.3 L GAS
View related parts
Chevrolet Blazer C.V. Joint, Outer
Part Number: 26037371
$325.46 MSRP: $589.06
You Save: $263.60 (45%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Outer CV Joint; Outer Joint; Joint Kit, Front Axle U Joint; CV Joint
- Position: Outer
- Replaces: 26037366
- Warranty: This genuine part is guaranteed by GM's factory warranty.
Fits the following Vehicles:
- 1992-1994 Chevrolet Blazer | Base, Cheyenne, Silverado, Silverado Sport | 8 Cyl 5.7 L GAS, 8 Cyl 6.5 L DIESEL
View related parts
Chevrolet Blazer C.V. Joint, Front
Part Number: 26037364
$272.97 MSRP: $494.06
You Save: $221.09 (45%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Joint Kit, Front Wheel Drive Axle; CV Joint; Outer CV Joint; Joint Kit, Front Axle U Joint
- Position: Front
- Replaces: 26020728
- Warranty: This genuine part is guaranteed by GM's factory warranty.
Fits the following Vehicles:
- 1992-1994 Chevrolet Blazer | Base, Cheyenne, Silverado, Silverado Sport | 8 Cyl 5.7 L GAS, 8 Cyl 6.5 L DIESEL
View related parts
Chevrolet Blazer Inner CV Joint
Part Number: 26037152
$125.65 MSRP: $225.39
You Save: $99.74 (45%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: CV Joints; CV Joint; Spider Assembly
- Position: Front
- Warranty: This genuine part is guaranteed by GM's factory warranty.
Fits the following Vehicles:
- 1992-1994 Chevrolet Blazer | Base, Cheyenne, Silverado, Silverado Sport | 8 Cyl 5.7 L GAS, 8 Cyl 6.5 L DIESEL
View related parts
Chevrolet Blazer Inner CV Joint
Part Number: 84666185
$79.35 MSRP: $124.29
You Save: $44.94 (37%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Outer CV Joint; Joint Kit, Front Wheel Drive Axle; CV Joint
- Position: Inner
- Warranty: This genuine part is guaranteed by GM's factory warranty.
Fits the following Vehicles:
- 2020-2021 Chevrolet Blazer | L, LT | 4 Cyl 2.5 L GAS
View related parts
Chevrolet Blazer Inner CV Joint, Front
Part Number: 84666178
$103.44 MSRP: $161.30
You Save: $57.86 (36%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Joint Kit, Front Wheel Drive Axle; CV Joint; Outer CV Joint
- Position: Front
- Replaces: 84207703, 84443365
- Warranty: This genuine part is guaranteed by GM's factory warranty.
Fits the following Vehicles:
- 2019-2021 Chevrolet Blazer | Base, L, LT | 4 Cyl 2.5 L GAS
View related parts
Chevrolet Blazer Inner CV Joint, Front
Part Number: 84666183
Product Specifications
- Other Name: Joint Kit, Front Wheel Drive Axle; CV Joint; Outer CV Joint
- Position: Front
- Replaces: 84148580
- Warranty: This genuine part is guaranteed by GM's factory warranty.
Fits the following Vehicles:
- 2020-2021 Chevrolet Blazer | LT, Premier, RS | 4 Cyl 2.0 L GAS, 6 Cyl 3.6 L GAS
View related parts
Chevrolet Blazer Inner CV Joint
Part Number: 84666171
Product Specifications
- Other Name: CV Joint; Outer CV Joint
- Position: Inner
- Replaces: 84609996
- Warranty: This genuine part is guaranteed by GM's factory warranty.
Fits the following Vehicles:
- 2019-2021 Chevrolet Blazer | Base, L, LT, Premier, RS | 4 Cyl 2.0 L GAS, 4 Cyl 2.5 L GAS, 6 Cyl 3.6 L GAS
View related parts
Chevrolet Blazer Inner CV Joint, Front
Part Number: 84446590
Product Specifications
- Other Name: Joint Kit, Front Wheel Drive Axle; Axle Shaft; CV Joint
- Position: Front
- Warranty: This genuine part is guaranteed by GM's factory warranty.
Fits the following Vehicles:
- 2019-2021 Chevrolet Blazer | Base, L, LT, Premier, RS | 4 Cyl 2.5 L GAS, 6 Cyl 3.6 L GAS
View related parts
Chevrolet Blazer Inner CV Joint, Front Passenger Side
Part Number: 26059678
Product Specifications
- Other Name: Joint Kit, Front Wheel Drive Axle; CV Joint; Joint Assembly; Inner Joint Assembly
- Position: Front Passenger Side
- Warranty: This genuine part is guaranteed by GM's factory warranty.
Fits the following Vehicles:
- 1997-2005 Chevrolet Blazer | Base, LS, LT, Trailblazer, Xtreme, ZR2 | 6 Cyl 4.3 L GAS
View related parts
Chevrolet Blazer Inner CV Joint, Front
Part Number: 84499586
$106.18 MSRP: $166.28
You Save: $60.10 (37%)
Product Specifications
- Other Name: Joint Kit, Front Wheel Drive Axle; CV Joint; Outer CV Joint
- Position: Front
- Replaces: 84240331, 84240335
- Warranty: This genuine part is guaranteed by GM's factory warranty.
Fits the following Vehicles:
- 2019-2021 Chevrolet Blazer | Base, LT, Premier, RS | 4 Cyl 2.0 L GAS, 6 Cyl 3.6 L GAS
View related parts
Chevrolet Blazer Outer CV Joint
Part Number: 26059673
Product Specifications
- Other Name: Joint Assembly; Outer Joint; Joint Kit, Front Axle U Joint; CV Joint
- Position: Outer
- Replaces: 26095325
- Warranty: This genuine part is guaranteed by GM's factory warranty.
Fits the following Vehicles:
- 1997-2005 Chevrolet Blazer | Base, LS, LT, Trailblazer, Xtreme, ZR2 | 6 Cyl 4.3 L GAS
View related parts
Chevrolet Blazer C.V. Joint, Outer
Part Number: 26055391
Product Specifications
- Other Name: Outer CV Joint; Joint Assembly; Outer Joint; Outer Joint Assembly; Joint Kit, Front Axle U Joint; CV Joint
- Position: Outer
- Replaces: 26028539, 26032312
- Warranty: This genuine part is guaranteed by GM's factory warranty.
Fits the following Vehicles:
- 1995-1996 Chevrolet Blazer | Base, LS, LT | 6 Cyl 4.3 L GAS
View related parts
Chevrolet Blazer C.V. Joint, Front
Part Number: 26037361
Product Specifications
- Other Name: Joint Kit, Front Wheel Drive Axle; CV Joint; Joint Kit, Front Axle U Joint
- Position: Front
- Replaces: 26025715
- Warranty: This genuine part is guaranteed by GM's factory warranty.
Fits the following Vehicles:
- 1992-1994 Chevrolet Blazer | Base, Cheyenne, Silverado, Silverado Sport | 8 Cyl 5.7 L GAS

Chevrolet Blazer CV Joint

Our website offers an extensive catalog of genuine Chevrolet Blazer CV Joint at unbeatable prices. Every OEM Chevrolet Blazer CV Joint comes with a manufacturer's warranty, an easy return policy, and rapid delivery service. Don't miss out on this great opportunity!

Chevrolet Blazer CV Joint Parts Questions & Experts Answers

Outer CV Joint
26059673
Q: How to replace the outer CV Joint and seal on Chevrolet Blazer?
A: To replace the wheel drive shaft outer joint and seal, collect the required tools: snap ring pliers (J 8059), seal clamp tool (J 35910), as well as drive axle clamp swage tool (J 36652), but as stated, there was no mention of any expiry date. The first step is to use a hand grinder to slice through the swage ring, and after that cut off the small boot clamp with side cutters. Slide the boot down the halfshaft bar and off the CV Joint outer race scooping out any grease. Separate the ears of the halfshaft bar retaining snap ring from the inside race of the inner race with the use of snap ring pliers (J 8059). Take off the CV Joint and boot from the halfshaft bar and discard the old boot. Use a brass drift to delicately strike and rotate the CV Joint cage in order to remove all six chrome alloy balls. Clean the inner and outer race assemblies, CV Joint cage and chrome alloy balls with cleaning solvent to make sure all the old grease and contaminants are erased, and then dry all the parts and check for wear or damage. Apply a thin layer of grease on the inner and outer race grooves, dovetail the inner race with the cage, and insert it. Install the cage and inner race into the outer race and thereafter use the brass drift to install the chrome alloy balls. Apply the pre-measured grease from the kit while packing the CV Joint boot and assembly, and put on the new small boot clamp on the CV Joint seal then slip the boot over the halfshaft bar ensuring it is torqued to 136 nm (100 ft. Lbs) using the seal clamp tool (J 35910). Make sure that the retaining ring side of the inner race CV Joint is towards the halfshaft bar and then slide the CV Joint to it and pull on to it to confirm engagement. Finally, slip the large diameter of the CV Joint boot over the CV Joint outer race and secure it tightly using the drive axle clamp swage tool (J 36652) and tighten the bolts while aligning tension and finally pull off the half heave assembly from the tool.

Related Chevrolet Blazer Parts

Browse Chevrolet Blazer CV Joint by Years

2021 2020 2019 2005 2004 2003 2002 2001 2000 1999 1998 1997 1996 1995 1994 1993 1992