Before beginning the left Engine Mount replacement process start by raising the car and eliminating underbody shields when they appear. You must first take off the through-bolt and its nut from the Engine Mount of the side being replaced before using a jack on the square tab (left side shown) at the engine block rear for engine lift while removing the
Starter if you need to access the right side tab. After raising the engine to its clearance height for removing the mount proceed with unthreading the bracket bolts from their frame brackets to complete bracket removal. Moove the Engine Mount through-bolt and nut from the mount as you take away the Engine Mount and its protective shield. Install the Engine Mount and shield as a unit after sub-assembly using one bolt before installing them onto the engine. Begin by mounting the engine to its location with 54 nm (40 ft. Lbs.), then proceed with mounting the frame bracket to the frame while tightening its bolts to 45 nm (33 ft. Lbs.). Physical workers should lower the engine with bolts at 74 nm (55 ft. Lbs.), then tighten the through-bolts at 74 nm (55 ft. Lbs.) and the nuts at 63 nm (46 ft. Lbs.). Reinstall the Starter only if it needed removal before lowering down the vehicle.