Other Name: Tire Pressure Monitor (Xl8-433Mhz); Sensor Package, Tire Pressure
Replaced by: 86530815
Warranty: This genuine part is guaranteed by GM's
factory warranty.
Fits the following Vehicles:
2023 Chevrolet Colorado | LT, Trail Boss, WT, Z71, ZR2 | 4 Cyl 2.7 L GAS
Chevrolet Colorado TPMS Sensor
Our website offers an extensive catalog of genuine Chevrolet Colorado TPMS Sensor at unbeatable prices. Every OEM Chevrolet Colorado TPMS Sensor comes with a manufacturer's warranty, an easy return policy, and rapid delivery service. Don't miss out on this great opportunity!
Chevrolet Colorado TPMS Sensor Parts Questions & Experts Answers
Q: How to replace the TPMS Sensor on Chevrolet Colorado?
A: First lift your vehicle using a proper support system and detach the tire along with wheel assembly. Before tire removal place the sensor's components on a clean dry surface with aluminum caps and nickel-plated valves to stop corrosion from occurring. For bead separation from wheel contact place the bead breaking fixture at a 90-degree angle to the valve stem then carefully insert the tire iron or pry bar just clockwise of the sensor body to pry upward and over the mounting/dismounting head. The tire machine requires clock-wise rotation of the tire/wheel assembly while moving tire beads to obtain proper rim positioning around the rim. Repeat this process for both tire bead layers. Run a thorough cleanup to remove every bit of remaining tire sealant from inside both the wheel surface and the tire. Evacuate the tire pressure sensor nut and its associated sensor from the wheel assembly. Installation begins with a cleaning of grommet sealing area followed by sensor insertion into wheel hole with air pass facing outward from wheel. Then install the sensor nut and adjust body position parallel to inside wheel surface before tightening the nut to 7 N.m (62 lb in). When ready to reinstall the tire use a mounting/dismounting head at 180 degrees from the valve stem while the bead transition area faces 45 degrees counterclockwise relative to the valve stem. After this, rotate the tire/wheel assembly clockwise to move the tire beads inside the wheel rim. Perform the same operation for the outer bead. The service replacement tire pressure sensor arrives in OFF mode so it needs to reach 32 km/h (20 mph) for ten seconds minimum to reach the internal roll switch before memory learning through the passenger door module (PDM). After installing the tire/wheel assembly onto the vehicle you should lower the vehicle before learning the tire pressure sensors.