Warranty: This genuine part is guaranteed by GM's
factory warranty.
Fits the following Vehicles:
1997-2003 Chevrolet Malibu | Base, LS | 4 Cyl 2.4 L GAS, 6 Cyl 3.1 L GAS
| Page 1 of 2 |Next >
1-20 of 29 Results
Chevrolet Malibu Control Arm
Our website offers an extensive catalog of genuine Chevrolet Malibu Control Arm at unbeatable prices. Every OEM Chevrolet Malibu Control Arm comes with a manufacturer's warranty, an easy return policy, and rapid delivery service. Don't miss out on this great opportunity!
Chevrolet Malibu Control Arm Parts Questions & Experts Answers
Q: How to replace the rear axle upper control arm on Chevrolet Malibu?
A: Begin by elevating the vehicle and using supports before removing the tire followed by the wheel. Rear axle vehicles with antilock brake systems (ABS) need their ABS harness connectors removed before placement aside along with documentation of its cable location for post-installation routing. The next step requires removal of the upper control arm to support assembly bolt as well as the upper control arm to knuckle bolt and nut before taking out the upper control arm through the wheel well opening. Set the upper control arm between support assembly and knuckle before you install its bolt to the knuckle with a manually tight nut. Service Precautions Fastener Notice requires strict compliance during all servicing operations. The upper control arm to support assembly bolt requires tightening to 60 Nm (44 ft. lbs.) with an additional 60 degree torque angle before the upper control arm to knuckle bolt receives a torque of 110 Nm (81 ft. lbs.) at 70 degrees. Put the ABS harness connector back in place while following the earlier route instructions. Lift the vehicle and place the tire and wheel before lowering it into position.