Other Name: Switch Assembly-Accessory; Windshield Washer Switch; Switch, Headlamp/Fog Lamp/Turn Signal
Warranty: This genuine part is guaranteed by GM's
factory warranty.
Fits the following Vehicles:
2009-2010 Chevrolet Silverado 1500 | Hybrid | 8 Cyl 6.0 L FULL HYBRID EV-FLEX (FHEV), 8 Cyl 6.0 L FULL HYBRID EV-GAS (FHEV)
| Page 1 of 2 |Next >
1-20 of 21 Results
Chevrolet Silverado 1500 Turn Signal Switch
Our website offers an extensive catalog of genuine Chevrolet Silverado 1500 Turn Signal Switch at unbeatable prices. Every OEM Chevrolet Silverado 1500 Turn Signal Switch comes with a manufacturer's warranty, an easy return policy, and rapid delivery service. Don't miss out on this great opportunity!
Chevrolet Silverado 1500 Turn Signal Switch Parts Questions & Experts Answers
Q: How to replace the Turn Signal Switch on Chevrolet Silverado 1500?
A: Disabling the SIR system requires specific safety steps before working on the turn signal switch. Take off the trim pieces from above and below before disconnecting the wire harness assembly from its strap. You should put back the abrasion sleeve on the wire harness assembly of the steering column and record where the connector goes for installation. Separate the SIR system coil connector from the two connectors (Turn Signal and Multifunction Switch Assembly) to release them from the bulkhead connector (Bulkhead Connector). Unfasten the two pan head tapping screws from the turn signal and multifunction switch assembly before taking it out of the steering column tilt head assembly. Set the turn signal and multifunction switch assembly onto the steering column tilt head assembly. Attach it with the two pan head tapping screws (Pan Head Tapping Screws) by tightening the top screw to 3 Nm (27 inch lbs.) for Domestic Column Shift or 7 Nm (62 inch lbs.) for Domestic Floor Shift and Export Column Shift while adjusting the side screw to 7 Nm (62 inch lbs.) for any configuration. The turn signal and multifunction switch assembly should maintain its electrical contact with the turn signal cancel cam assembly base. Put the connector ends of the Turn Signal and Multifunction Switch Assembly into the Bulkhead Connector and dock it to the SIR coil connector. Put the wire harness assembly back into the wire harness strap while lowering the connector and ignition cylinder case wires into the sleeve correctly. Put back the upper and lower trim parts then reactivate the SIR system.